|
Body Features |
4 Row
Body |
5 Row Body |
| STRUCTURE: |
(5) One piece bows (1 7/8"
deep x 16 gauge) |
(6) One piece bows (1 7/8" deep x 16
gauge) |
| FLOOR
STRUCTURE: |
14 Gauge galvanized steel floor panels;
(1) Cross member 3
3/4" high - 1/8" steel
(5) Intermediate 2 1/2" - 3/16"
steel
(6) Hold-on clamps with rubber pad
(6) Offset "J" clamps
with rubber pad
Rubber cushion mounted cross member at rear |
14 Gauge galvanized steel floor panels;
(2) Cross member 3
3/4" high - 1/8" steel
(5) Intermediate 2 1/2" - 3/16"
steel
(4) Hold-on clamps with rubber pad
(2) Offset "J" clamps
with rubber pad
|
| FLOOR: |
Plywood: 1/2" B.C. Fir
(fastened to base floor)
Standard covering: black rubber (ribbed
aisle, smooth under seats) cove molding around edge |
| REAR EXTENSION: |
(2) 11 gauge frame rails |
| BUMPER: |
Rear: 7" wide X 1/8"
thick, wrap around 10" with metal trim each side end |
| PANELS: |
Exterior: roof
panels & side panels (to floor level) are epoxy pre-primed aluminum
(0.04"); side panels (floor level and below) are epoxy
pre-primed glvanized steel (20 gauge)
Interior: stucco
clear-coated aluminum sides (window line to seat rail); epoxy
pre-primed aluminum (0.04") roof headlining |
| RUB RAILS: |
(2) Embossed
rub rails, (1) 4 1/2" x 16 gauge applied at seat cushion level
extending around rear corner, (1) 4 1/2" x 16 gauge applied at floor
level (no extension). Rub rail cap. |
| DRIP MOLDING: |
Formed in roof panels over side window. |
|
DOORS |
|
| DRIVERS: |
As supplied by Ford |
| ENTRANCE: |
Front right side; manually
controlled opening device. Outward opening of 32"X74"
(4) fixed
glass panels; header padded inside; (2) step stepwell; moulded front
corner with flat glass. |
| REAR EMERGENCY: |
Center outward opening
from left to right
Clear opening of 34" x 54"; top and bottom safety
glass.
Header padded inside; safety guard for interior handle
Non-hitch
and recessed exterior handle.
Strap hinges with grease fitting;
buzzer signal. |
| STORAGE COMPARTMENT: |
Located above driver, left side, one latch. |
| PAINT: |
Exterior: National School
Bus Chrome Yellow Interior: Grey |
| UNDERCOATING: |
Complete body underfloor, body skirt and
rear fenders. |
| INSULATION: |
1 1/2" thick fibreglass between roof, side
and rear panels; undercoating sprayed on inside of exterior
panels. |
| WIRING HARNESS: |
Main body wiring enclosed in protective
loom; electrical panel located in cabinet upper left of
driver’s seat. Circuit protection (breaker); Color-coded and
accessory labeled main harness concealed behind removable
cover left side above windows. INCLUDES WIRING FOR: 8 way
warning system, front buzzer |
| BARRIERS & SEATS |
Seats & barriers are certified to meet all Federal
Standards relative to type II School buses; seats
upholstered with 42 oz. grey leatherette. Seat cushion depth
of 15"; seat frames are painted black with an e-coated
enamel; they come standard with seat belt attachment. |
|
GLASS |
|
|
ENTRANCE DOOR: |
(4) panes of clear
tempered glass |
| CORNER
PANEL: |
(1) pane of clear tempered
glass. |
| REAR
DOOR: |
Clear tempered glass (top
and bottom) |
| REAR
STATIONARY: |
Clear tempered glass |
|
WINDOWS: |
(1) each side of emergency
door. |
| SIDE
SASH: |
(8) aluminum framed side
split sashes; maximum opening of 25 1/2" x 9"; clear tempered glass. |
(8) aluminum framed side
split sashes; maximum opening of 25 1/2" x 9"; clear tempered
glass.(2) aluminum framed side split sashes with opening of 22" x 9" |
| FENDERETTE: |
Installed on rear
wheelhouse (optional) |
| GRAB RAIL: |
Entrance door left side; mounted at
stepwell and seat barrier. |
| LETTERING: |
Per state regulations |
|
LIGHTS |
|
|
BACK-UP: |
(2) 3 3/4" round clear
lights mounted on both rear corners at belt line |
|
CLUSTER: |
(3) amber lights on upper
front; (3) red lights on upper rear |
|
DIRECTIONAL: |
Front: as supplied by Ford
Rear:
(2) 7" rectangular plain amber |
| DOME: |
(2) rows of (2) lights
above passengers seats (1) light above driver’s seat |
| MARKER: |
(2) front amber lights;
(2) rear red lights (one per side on
top corners) |
|
REFLECTORS: |
(4) red: (2) at rear and
(2) on side rear at bumper level |
| STOP /
TAIL: |
(2) 4" round red tail
lights with license plate light, mounted on both rear corners below
belt line
(2) 7" rectangular red stop lights, mounted on rear above
belt line |
| SWITCH
PANEL: |
Electrical keyboard over
door control pedestal. |
| MIRRORS: |
Exterior: 7" x 10" Mirrors with 5" convex
both sides and crossview mirrors |
| VENTILATOR: |
One static
exhaust ventilator located in center of front section |
| The CORBEIL SINGLE WHEEL
SCHOOL BUS is certified to meet or exceed all FEDERAL MOTOR VEHICLE
SAFETY STANDARDS in effect on date of manufacture |
| ***ALL
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE*** |
